HED Cycling Products

Product finder:

Select one Jet Disc - Flamme Rouge Jet disc clincher Jet disc tubular Stinger disc - Flamme Rouge Stinger disc --------------- H3 Tubular H3 Clincher H3D Tubular H3D Clincher --------------- Jet 4 Jet 6 Jet 9 Stinger 4 Stinger 6 Stinger 9 --------------- Jet 4 Flamme Rouge Jet 6 Flamme Rouge Jet 9 Flamme Rouge Stinger 4 Flamme Rouge Stinger 6 Flamme Rouge Stinger 9 Flamme Rouge Scorpio Flamme Rouge Ardennes C2 Flamme Rouge --------------- Ardennes C2 Bastogne C2 Kermesse C2 Flanders --------------- Track wheels PowerTap 650c/Recumbent --------------- Hed Corsair Aerobar Hed Black Dog Drop Clip Lite Third Brake Lever

Care and feeding of your valve extenders:

Valve extenders should be installed before the tube or tire is installed or glued on.

1. Unscrew your valve as you normally would to pump up your tire, then grip it tightly and give it an extra twist open. You want to wedge the stem open so that it will not vibrate shut while riding.
2. Procure some teflon pipe sealing tape. A roll can be bought at a hardware store of home center in the plumbing section. Put four wraps of tape clockwise around the stem, right where the extender will screw on. The tape provides an airtight seal so that a pump gauge will read.
3. Screw the extender on and leave it on the tube or tire after you install it.

It is not a bad idea to put an extender on your spare tube or tire, it is one less thing to mess with on the road if you get a flat.

 

Technical:
Materials
What is Stall Angle?
FAQ
Warranty Information

How To's:
Wheel Magnets
Valve Extenders

About HED | Wheels | Aerobars | Accessories | Technical | Aerodynamics & Technology | Warranty Information | Athletes | Dealer Locator | Shopping | Media | Contact
Copyright © 2008 - 2010 Hed Cycling Products - All rights reserved

Site by: Blue Designs Inc.